One Fault: The shower faucet is out of the water fork or the water volume is reduced, there is no bubble phenomenon Cause: The bubbler filter is fouled or obstructed by debris (the bubbler is a complete structure of the tap nozzle), which acts to foam the water flowing out of the tap through the tap. Method: Remove the spout and clean the filter two Fault: Small amount of shower water, water fork Cause: Low water pressure or debris in the shower head Method: Unscrew the shower with a filter or remove the rubber gasket with a filter or wash the shower
three Fault: No noise is present in the body or piping when the faucet is turned off Cause: The water pressure in the home is too high; the faucet handle is rapidly closed; the hot and cold water pipes are not well fixed; there are obstructions in the inlet pipe, causing a sharp change in water pressure. Method: Reduce the water supply pressure (close the triangular valve) to avoid the rapid closing of the faucet. Re-construct, clean the pipeline, check the water pipe and connect objects (such as water purifiers, water heaters) for any bad combination. four Fault: Temperature adjustment is not easy, water temperature often changes Cause: The difference between the hot and cold water pressure is too large, or the water heater has insufficient ability to raise the water temperature. Method: Turn the hot and cold triangle valve of the water heater to a small (counterclockwise rotation) to balance the pressure to ensure that the water temperature of the water heater can keep up with the water output speed. Fives Fault: Unable to get higher water temperature Cause: The water heater is not enough, and the temperature control knob is not in the right position. Method: Adjust the temperature control knob or switch to a high-power water heater
hand held bidet faucet shower faucet shattaf bidet faucet
six Fault: Water leaks at hose and faucet connection Cause: Improper installation, deformation of the rubber ring, uneven or too thin outlet pipe joint Method: Replace the rubber ring and reinstall it. When installing the hose joint, it should not be too strong, causing damage to the hose of the water pipe. Seven Fault: The basin faucet and the kitchen faucet have a small amount of water and do not blister. Cause: The water pressure is low and the bubbler cannot generate bubbles. Method: Remove the faucet nozzle and change the bubbler
We have a wealth of business experience. We provide satisfactory products and services to our customers around the world. Our products include shower faucet,hand held bidet faucet Please contact us。http://www.haoluu.com/
Just say hello and Leave Your Messages
We have received your message, we will contact you very soon.
Oops! Something went wrong please refresh the page and try again.
Room 435,No. 1-3 West Fanghu 2nd Road,Huli District,Xiamen